The motor is built as of October 2023 by Forced Air Technologies. The mileage is only on chassis and drivetrain.
Only issues are minor cosmetic from age. Only 10k and slowly counting on motor since build. No Rust , West coast vehicle.
R888R Tires installed Nov. 2024. very few miles on them garage kept.
Just got car back May 7, 2025 from installing New Flex Fuel Kit along with IAT harness and Air Temperature sensor, and Speed Density Wiring Kit. Same Pro tune gone over. Just Installed CRF radiator. White line front and rear sway bar with front and rear control arm bushings as of September 2025.
I will provide all receipts in person and we can go for a drive for seriously interested parties. Engine build explained below.
FAT STAGE 2 COMPONENTS
FAT Stage 2 2.5L Short Block Includes:
– JE Pistons – JE 99.75mm (8.5:1) Forged Pistons- JE Pistons Ring Set & Wrist Pins- Manley H-Beam Connecting Rods- ARP 2000 Head Studs- ACL Race Series Main Bearings- ACL Race Series Rod Bearings- Case / Main Bolts – Standard Subaru case bolts-Cometic MLS Head Gaskets-OEM Subaru Seals & O-rings-Gates Japan Timing Belt Kit
Complete STG2 Engine Assembly
Complete Engine Assembly And Transfer Necessary Part.
Measure Cylinder Bores, Crankshaft & Pistons For Proper Size & Hone Cylinders.
Install JE Pistons, JE Rings Manley H-Beam Rods, ACL Main & Rod Bearings. Clean
Or Renew Parts That Are Not Being Replaced. Transfer All Fuel and Electrical Units
& Make All Necessary Adjustments Before Reinstall of Engine.- Specific Piston Ring Gap Set- Bearing Clearance Checked- Deck Height Checked- Rod Side Clearance Checked- Engine Block Honed To Accept JE Pistons- Assembled by Forced Air Technologies
Machine work
Cylinder Head Service / Adjust Valve Lash Adjustment
PART
Garrett Billet 3071 Turbo
AEM High Flow Fuel Pump E-85
COBB Front Mount Intercooler Black / Black
COBB Complete Intake System
PERRIN Turbo Inlet black
Tune Paid to Clark Turner Tuning At Tuning
IAG AOS along with a Fluidampr viscous Internally balanced damper.
2004 STI Pick up and Oil Pan